Installation, Administration and Maintenance
Aastra Telecom Page: 21 (47)
Each application SW comes with the latest released booter SW. The
application SW will update the booter automatically as long as the major
release number of the booter SW has not changed, e.g booter SW 2.1.2 will
not be automatically updated by the booter SW 3.x.y, but the booter SW
3.0.0 will be automatically updated by the booter SW 3.1.0.
3.1.4.1.2 Automatic booter update for major release changes
The update of booters with a major release number change will be performed
automatically when the DHCP client in the application receives an DHCP
offer with the public option 254 with a value “UPDATE”.
3.1.4.2 Selecting the right DHCP server
The DHCP client requests its own IP address using code 50. The DHCP
client will select the DHCP server that offers the currently used IP address.
Additionally the mandatory options must be offered otherwise the DHCP offer
is ignored by the DHCP client.
If no matching reply was received the DHCP client resends the request for 2
times after 1 second. Then the DHCP client will wait for 1 minute before
resending 3 requests again.
If the DHCP client cannot accept an DHCP offer within 3 minutes the RFP is
rebooted.
3.1.5 RFP LED status
The following diagram shows the LED status of a RFP according to the
different states during start up.
The RFP32 IP has three separate LEDs for red, orange and green to show
the different states during start up.
Power jack (120 V/230 V AC adapter)
Ethernet jack
Power supply in line with Power over LAN™
standard IEEE 802.3af
LED red (Booter)
RFP32
LED orange (Application)
LED green (Application)
Unused LED
State LED state Remarks
Booter (Start up) Red on Waiting for link up
Booter DHCP Red flashing 0.5 Hz Launching a DHCP request and
waiting for an DHCP offer
To Next Page
Loading...
Need help?
General
