35266HSH MODBUS TRANSMITTER | PRESSURE/TEMPERATURE MULTIVARIABLE | OI/266HSHMT-EN REV. A
instructions included with the handheld terminal.
according to customer specifications for the measuring
purposes.
software for the steps required to install the operating
tool. The most important parameters can be set via the
testing the transmitter.
means of an internal database.
7.13 Configuration with the graphical user
interface (DTM) - System requirements
relevant operating instruction.
7.14 Standard and Advanced HART: functionality
266 Pressure Transmitters can be codified with:
Configuration via HMI On board Not available
SIL certified On board Not available
PILD On board On board
Trend On board Not available
Totalizer On board On board
Service Port On board Not available
Electronic replacement On board Not available
7.15
Description
date
From To
7.1.11 First release 09/2009
7.1.11 7.1.12
Bug Fixing:
— microbar and millitor units added
— HART command 35 bug fixed. By HART
specificaiton #35 unit should not be
set pv unit
— if the local indicator was not mounted,
only one operation via push buttons
was performed
— MWP diagnosis classification become
Maintenance instead of
Off-Specification
Improvements:
— replacement functionality improved
— internal improvements to reduce
factory configuration
— more/stronger checks about process
variables goodness
— HART response time reduced (30%)
06/2010
7.1.12 7.1.14
Improvements:
— factory configuration speeded up
— service detailed diagnosis
implemented
01/2011
7.1.14 7.1.15
Bug Fixing:
— sensor trimming via local display was
performend only in kPa
— diagnosis “Replace Error” no more
shown
— unit strings on display (Nm3, bbl, t)
were wrong
New Features:
— new language (French & Spanish) on
local indicator
— sensor polarity invertion
01/2013
7.1.15 7.2.1 HART 7 implementation 11/2015
7.1.15
7.2.1
7.1.16
(HART 5)
7.2.2
(HART 7)
New Features:
— Temperature alarm enabled by user
— oscillation alarm control
— switching of alarm for wrong power
supply
10/2018
7.15
7.16