Operation Manual / A150-M56/66/57/67 - A155-M..
10 Dismantling and fitting with removed air inlet and gas outlet / 10.5
Removing the compressor casing
© Copyright 2021 ABB. All rights reserved. HZTL4032_EN Rev.Q January 2021
10.5 Removing the compressor casing
Removing the compressor casing
u Mark the casing position for assembly.
Fig.57: Removing the compressor casing
If the compressor casing cannot be loosened, it can be pressed off against the turbine cas-
ing with the press-off tool (90042).
1. Loosen screws(72011) and remove together with fastening strips(72012).
2. Attach swivel lifting eye (S) to the compressor casing and the lifting gear.
3. Remove the compressor casing (72000) and turn it 180°.
4. Put the compressor casing (72000) down onto a suitable support.
5. Remove and dispose of the O-ring(42012).
Page 105 / 194
To Next Page
Loading...
