Operation Manual / TPS48-D/E.. - TPS61-D/E..
Expected exchange intervals
Page 48
© Copyright 2016 ABB. All rights reserved.
September 2016 HZTL2410_EN Revision E
Expected exchange intervals
4.3
The recommended replacement intervals for compressor wheels and tur-
bine wheels are defined depending on the operating conditions and based
on the safety concept (SiKo) for rotating parts. These intervals can be
found on the turbocharger rating plate.
Depending on the system-specific operating conditions, a distinction is
made between:
the replacement interval for the bearing parts and
the replacement interval for those non-rotating components that are
exposed to hot gases.
Decisive in this respect are various influencing parameters, which can
drastically shorten the replacement intervals of these parts in extreme
cases.
During the specified periodic service work, the individual components are
inspected for wear and, if necessary, replaced.
Expected replacement intervals [h]
Turbine casing 25000 … 50000 25000 … 50000
Gas outlet flange 50000 35000 … 50000
Rotor components See the data on the rating plate
Other casings 50000 50000
GAS = Natural gas MDO = Marine diesel oil HFO = Heavy fuel oil
The specified values are a guide only and not guaranteed (see following
section Influencing parameters).
To Next Page
Loading...
Need help?
General
