Operation Manual / TPS48-D/E.. - TPS61-D/E..
Page 54
© Copyright 2016 ABB. All rights reserved.
September 2016 HZTL2410_EN Revision E
4.5
Stopping the engine of oil-cooled turbocharger version
Heat in the turbocharger must be dissipated by the further circulating
lubricating oil.
Post-lubricate for 15 … 20 minutes.
Maintain oil pressure of 0.5 … 1.0 bar for post-lubrication.
Stopping the engine of water-cooled turbocharger version
Heat in the turbocharger must be dissipated.
Allow turbocharger cooling water to run for 15 … 20 minutes after
stopping engine.
Allow oil lubrication to continue running until rotor comes to a stop.
Further post-lubrication is not required and not recommended.