25
Performing a Control Test
The meter, a test strip, and control solution are needed.
1. Insert the test strip into the
meter in the direction of the
arrows. The meter turns on.
2. Make sure the code number
on the display matches the
code number on the test strip
container. If the code number
is overlooked, remove the test
strip and reinsert it into the
meter.
3. Select the control solution to
be tested. The level is entered
later.
Note:
Cap color may vary – refer to the control solution package insert.
or
(example)
To Next Page
Loading...
Need help?
General
