v
FCC Notice
This device has been tested and found to comply with the
limits for a Class B digital device pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This device generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this device does cause
harmful interference to radio or television reception, which
can be determined by turning the device off and on, the
user is encouraged to try to correct the interference by one
or more of the following measures:
1. Reorient or relocate the receiving antenna
2. Increase the separation between the device and receiver
3. Connect the device into an outlet on a circuit different
from that to which the receiver is connected
4. Consult the dealer or an experienced radio/television
technician for help
Notice: Shield Cables
All connections to other computing devices must be made
using shielded cables to maintain compliance with FCC
regulations.
Notice: Peripheral Devices
Only peripherals (input/output devices, terminals, printers,
etc.) certified to comply with the Class B limits may be
attached to this equipment. Operation with non-certified
peripherals is likely to result in interference to radio and TV
reception.
Notices
500-e.book : 500-eNOT.fm Page v Monday, August 17, 1998 9:36 PM
To Next Page
Need help?
General