28
Management
ECO Mode
Choose "ECO" to dim the projector lamp, which will also
lower the power consumption, reduce noise, and extend
the lamp life. Choose "User" allows you to adjust the light
source power. Choose "Off" to return to the normal mode.
Light Source
Power
This function is only available when "Custom" is selected
in the ECO Mode menu. You can adjust the light source
power to extend the light source life and decreases the fan
noise.
High Altitude
Choose "On" to turn on the High Altitude mode. When
this function is turned on, the projector fans operate at full
speed continuously to cool down the projector’s
temperature.
Auto Shutdown
(Minutes)
The projector will automatically shut down while there is
no signal input detected after the time you set.
Menu Display
Time (Seconds)
• 5/15/30: Chooses the length of time the OSD menu
will remain active after your last key press.
• Manual: The OSD menu remains active. The only way
to launch or exit the OSD menu is by pressing
"BACK".
Auto Power On
AC Power On
Selecting "On" enables the function. The projector will
automatically turn on when power is supplied via the
power cord.
HDMI Power On
Selecting "On" enables the function. The projector will
automatically turn on when power is supplied via the
power cord and the HDMI signal is supplied via the HDMI
cable.
VGA Power On
Selecting "On" enables the function. The projector will
automatically turn on when power is supplied via the
power cord and the VGA signal is supplied via the VGA
cable.
To Next Page
Loading...
Need help?
General
