8
fig 8
1) Use four Expansion Setscrew to install
the hanger bracket to the wall firmly
(fig 8).
Note: The hanger bracket must be
vertical to the floor.
METHOD OF INSTALLATION – WALL MOUNT
INSTALLATION OF HANGER BRACKET:
fig 9
1) Remove the ‘R’ pin, nut and cross pin from the downrod.
2) Install the canopy and decorative cover through the downrod then thread
the wires through the downrod, insert the downrod into the coupler as
(fig 9).
3) Install back the cross pin, nut and secured with the ‘R’ pin. The ‘R’ pin
must be properly installed to prevent the cross pin from working loose.
Tighten the two setscrews on the coupler (fig 10).
INSTALLATION OF DOWNROD:
fig 10
To Next Page
Loading...
General