4-51
MegaZoom Concepts and Oscilloscope Operation
To save traces and setups to a new file on the floppy disk
To save traces and setups to a new file on the floppy disk
1 To create a new file name, press the New File softkey.
If you do not want to overwrite an existing file, use this menu to enter a new
file name. New file names can be up to eight characters long. New file names
can only be written to the floppy disk, not the internal memory.
2 Turn the Entry knob to select the first character in the file name.
Turning the Entry knob selects a character to enter into the highlighted position
shown in the "New file name =" line above the softkeys and in the Spell
softkey.
3Press the Enter softkey to enter the selected character and go to the next
character position.
You may position the highlight on any character in the file name by successively
pressing the Enter softkey.
4 To delete a character from the file name, press the Enter softkey until
the letter you want to delete is highlighted, then press the
Delete Character
softkey.
5 When you are done entering characters for the file name, press the
Press to Save softkey to save the file.
Two files will be saved to the floppy disk. In the example above, SCOPE1.TRC
will be the trace file and SCOPE1.SCP will be the setup file. You do not need
to remember these file extensions because you can select trace, setup, or both
when you recall this information using the Recall menu.
To Next Page
Loading...
Need help?
General
