Agilent Technologies 6063B User Manual

37
Table 3-6. Primary Interface S.A. Test No. 3
Description:
These signatures check the front panel interface IC's U208 U209, U210 and U212. The signatures are
valid for ROM U205 firrnware revision "Rev A.02.01". Use the test setup described in "Test Setup for S.A.''. Connect
the signature analyzer's CLOCK input to the chip select line of the IC under test as specified below.
U208-U212 Drivers--Connect CLOCK to U207-11 Signatures
U208-3 U209-17 U210-18 7H05
U208-7 U209-lB U210-16 8P29
U208-4 U209-14 U210-14 U864
U208-8 U209-13 U210-12 3P59
U208-13 U209-8 U210-9 44A9
U208-14 U209-7 U210-7 C4P4
U208-17 U209-4 U210-5 8PUC
U208-18 U209-3 U210-3 2794
U208-1 U209-1 U961 + 5V
U208-10 U209-10 U210-10 OOOO common
U208-11 U961
U209-11 U961
U208-16 U28H
U208-2 2171
U208-5 1687
U208-6 899A
U208-9 1233
U208-12 762C
U208-15 85F9
U208-19 5255
U209-2 6199
U209-5 3C52
U209-6 U212-1 5F9A
U209-9 U212-5 62C5
U209-12 U212-9 2334
U209-15 U212-3 6873
U209-16 U212-13 1716
U209-19 U212-11 99AP
U210 Keypad Receiver--Connect CLOCK to TP201-13 (CSP4)
U210-1,19 = OOOO pulsing
U210-2 = 06U1
U210-3,17,20 = 07U3
U210-4 = 07U3 + 5 V ( cal lock when low )
U210-5,15 = 07U3 press keypad "ADDRESS" = O7C3
U210-6,14 = 07U3 press keypad "INPUT" = O772
U210-7,13 = 07U3 press keypad "LOCAL" = O7C3
U210-8,12 = 07U3 press keypad "VOLT" = O7UC
U210-9,11 = 07U3 press keypad "RECALL" = O7C3
U210-10 = OOOO common
U210-16 = O7U3 if CAL LOCK low = OOOO pulsing
U210-18 = O6U1 pulsing

Agilent Technologies 6063B Specifications

General

Brand	Agilent Technologies
Model	6063B
Category	Accessories
Language	English