NOTE!
Improper cleaning can damage the device.
- Do not use any harsh cleaning products, brushes with metal
or nylon bristles, or sharp or metallic cleaning materials such
as knives, hard scrapers or similar. They may damage the
surfaces.
- Remove wet cuttings immediately. Residues of wet cuttings
on and in the device may harden and cause mould.
Cleaning and inspection after each use
Regular cleaning and inspection is necessary to keep the device in
perfect state.
1. Stop the motor and wait until the blade stands still.
2. Disconnect the device by unplugging the power cable and remove the power
cable from the pull relief
2
.
3. Thoroughly empty the collecting bag
5
(see "Emptying the collecting bag")
without reattaching it to the device.
4. Remove cuttings from the device and the collecting bag 5 with a hand brush.
5. Tip the device on its side and remove cuttings from the discharge chute and
blade compartment with a hand brush or a brush.
6. Check the blade for damaged spots and wear.
Do not operate the device with a damaged or worn blade! If necessary, have the
blade sharpened or exchanged in a specialist workshop (for the blade type, see
"Technical specifications").
7. Set the device upright again.
8. Check all connections (handle, collecting bag) for tight fit.
The device is ready for storage.
Maintenance
Apart from the measures described in the section "Cleaning and inspection after
each use", the device is principally maintenance-free. You do not have to lubricate or
readjust any parts.
Cleaning
16
To Next Page
Loading...
Need help?
General
