Problem Possible cause Fault rectification
Unsteady run
The device emits unusual
noises
Insufficient power
The selected cutting height is
too low.
Set the cutting height 2 levels
higher.
Collecting bag is full to the
rim or the discharge chute is
clogged.
Empty the collecting bag and
remove cuttings from the
discharge chute.
Blade is blocked by foreign
object.
Check the blade
compartment for foreign
objects and remove these if
present.
Blade is dull or damaged. Check the blade and have it
sharpened or replaced at a
specialist workshop, if
necessary.
Cuttings left on ground Collecting bag is full to the
rim or the discharge chute is
clogged.
Empty the collecting bag and
remove cuttings from the
discharge chute.
Grass is too wet. Wait for the grass to dry.
If the problem persists, contact the customer service listed on the last page.
Technical data
Model GLM44
Rated voltage/frequency: 230–240 V~/50 Hz
Rated power: 1800 W
Protection class: II
IP rating: IPX4
Max. rpm: 3500 min
-1
Weight (net): 16.5 kg
Dimensions (H x L x W) 1160 × 1180 × 475 mm
Cutting width: 440 mm
Troubleshooting
19
To Next Page
Loading...
Need help?
General
