To exit the Water Level Test, press the WARM (<) keypad. The
control will return to the Testing Mode.
Configuration 1 Display Test d 29
This option shows the machine configuration values. To start test,
control must be in the Testing Mode. Refer to How to Enter Test-
ing Feature at the beginning of this section.
To enter, press the START (enter) keypad. For configuration val-
ue #1, the display will show A XXX. XX is a number correspond-
ing to whether or not coin drops are connected, a card reader or
network board are connected, or whether the life-test jumper is
present. Refer to Table 15 .
To exit a Configuration Display Test, press the WARM (<) key-
pad. The control will return to the Testing Mode.
Each column of the table below contains a unique combination of
the words “YES” and “NO” that indicates if that column’s con-
nection is present.
Testing Machine and Electronic Control Functions
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
75 Part No. 204370ENR1
To Next Page
Loading...
Need help?
General