Alpine CDE-173EBT User Manual

26-EN
ALPINE CDE-170E 68-40368Z02-A (EN) 128x182
Troubleshooting
The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check
the connection and operating procedures.
For details on using the fuse and removing the
unit from the dashboard, see “Connection/
Installation” (page30).
If the problem is not solved, please contact your
authorized Alpine dealer for assistance.
General
No sound or the sound is very low.
The position of the fader control [FADER] is not
set for a 2-speaker system.
The volume of the unit and/or connected
device is very low.
– Increase the volume of the unit and
connected device.
No beep sound.
An optional power amplifier is connected and
you are not using the built-in amplifier.
The contents of the memory have been
erased.
The power supply lead or battery has been
disconnected or not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes a noise when the position of the
ignition is switched.
The leads are not matched correctly with the
car’s accessory power connector.
During playback or reception, the
demonstration mode starts.
If no operation is performed for 5 minutes
with [DEMO ON] set, the demonstration mode
starts.
– Set [DEMO OFF] (page 19).
The display disappears from/does not appear
in the display window.
The dimmer is set to [DIMMER ON] (page
20).
The display disappears if you press and hold
(power).
– Press
(power) on the unit until the display
appears.
The connectors are dirty (page 23).
The display disappears while the unit is
operating.
[BLACK OUT] is set to [ON] (page 20).
The display/illumination flashes.
The power supply is not sufficient.
– Check that the car battery supplies enough
power to the unit. (The power requirement
is 12 V DC.)
The operation buttons do not function.
The disc will not eject.
Press and Number button 6 for more than 2
seconds to reset the unit.
The contents stored in memory are erased.
For your safety, do not reset the unit while you
are driving.
Radio reception
Stations cannot be received.
The sound is hampered by noises.
The connection is not correct.
– Check the connection of the car antenna
(aerial).
– If the auto antenna (aerial) will not extend,
check the connection of the power antenna
(aerial) control lead.
Preset tuning is not possible.
The broadcast signal is too weak.
RDS
PTY displays [- - - - - - - -].
The current station is not an RDS station.
RDS data has not been received.
The station does not specify the program type.
CD play
The disc d
Defectiv
The CD
22).
MP3/WM
The disc
AAC for
MP3/WM
others.
The foll
playba
c
– A disc
struct
– A disc
– A disc
The soun
Defectiv
USB dev
You canno
This un
USB hu
A USB de
v
The USB
complic
The soun
The sou
rate.
DRM (D
not be p
The audio
USB dev
than FA
* This unit s
device ma
refer to th
contact th

Alpine CDE-173EBT Specifications

General

Brand	Alpine
Model	CDE-173EBT
Category	Car Receiver
Language	English