Alpine CDE-173EBT User Manual

29-EN
ALPINE CDE-170E 68-40368Z02-A (EN) 128x182
it and the
red in a
ove the
e.
devices
arby.
er devices.
ily when
d the
not a
vice
TH audio
orts the
er a call
e, the time
he time.
e.
er) for
nit on
kers
ar phone,
ound
r an
on.
with the
Messages
The following messages may appear or flash
during operation.
If these solutions do not help improve the
situation, consult your nearest Alpine dealer.
If you take the unit to be repaired because of CD
playback trouble, bring the disc that was used at
the time the problem began.
CD ERROR: The disc cannot be played. The disc
will be ejected automatically.
Clean or insert the disc correctly, or make sure
the disc is not blank or defective.
CD NO MUSIC: There is no playable file. The disc
will be ejected automatically.
Insert a disc containing playable files (page
24).
CD PUSH EJT: The disc could not be ejected
properly.
Press and hold (eject).
HUB NO SUPRT: USB hubs are not supported.
INVALID
The selected operation could be invalid.
[USB MODE] cannot be changed during iPod
playback.
IPD STOP: iPod playback has finished.
Operate your iPod/iPhone to start playback.
NOT SUPPORT - ANDROID MODE
A USB device not supporting AOA (Android
Open Accessory) 2.0 is connected to the unit
while [USB MODE] is set to [ANDROID].
– Set [USB MODE] to [MSC/MTP] (page 19).
OVERLOAD: The USB device is overloaded.
Disconnect the USB device, then press
SOURCE
to select another source.
The USB device has a fault, or an unsupported
device is connected.
READ: Now reading information.
Wait until reading is complete and playback
starts automatically. This may take some time
depending on the file organization.
USB ERROR: The USB device cannot be played.
Connect the USB device again.
USB NO DEV: A USB device is not connected or
recognized.
Make sure the USB device or USB cable is
securely connected.
USB NO MUSIC: There is no playable file.
Connect a USB device containing playable files
(page 24).
USB NO SUPRT: The USB device is not
supported.
For details on the compatibility of your USB
device, consult your nearest Alpine dealer.
or : The beginning or the end of
the disc has been reached.
(underscore): The character cannot be
displayed.
For BLUETOOTH function:
BTA NO DEV: The BLUETOOTH device is not
connected or recognized.
Make sure the BLUETOOTH device is securely
connected, or the BLUETOOTH connection is
established with the BLUETOOTH device.
ERROR: The selected operation could not be
performed.
Wait for a while, then try again.
UNKNOWN: A name or phone number cannot
be displayed.
WITHHELD: The phone number is hidden by the
caller.

Alpine CDE-173EBT Specifications

General

Brand	Alpine
Model	CDE-173EBT
Category	Car Receiver
Language	English