RS2240003 Rev. 0 4
WARNING
!
To avoid risk of electrical shock, personal injury or
death; make sure to follow grounding instructions.
Grounding Instructions
WARNING
!
Do not remove grounding prong when installing
grounded appliance in a home or business that does
not have three wire grounding receptacle. Under no
condition is grounding prong to be cut off or removed.
It is the personal responsibility of the consumer to
contact a qualified electrician and have properly
grounded three prong wall receptacle installed in
accordance with appropriate local electrical codes.
Should a two prong adapter plug be required temporarily
it is the personal responsibility of the consumer to have it
replaced with a properly polarizied and grounded three
prong receptacle or the two prong adapter properly
grounded by a qualified electrician in accordance with
appropriate electrical codes.
Servicing of Grounded Products
The standard accepted color coding for grounding wires
is GREEN or GREEN WITH YELLOW STRIPE. These
ground leads are NOT to be used as current carrying
conductors. It is extremely important that the technician
replace any and all grounds prior to completion of the
service call. Under no condition should ground wire be left
off, which can cause a potential hazard to technicians
and consumer.
WARNING
!
Precautions to be observed before and during
servicing to avoid possible exposure to excessive
microwave energy or electrical shock, disconnect
power to oven.
Do not operate or allow oven to be operated with door
open.
Make the following safety checks on all ovens to be
serviced before activating the magnetron or other
microwave source, and make repairs as necessary:
• Interlock operation
• Proper door closing
• Seal and sealing surfaces (arcing, wear, and other
damage)
• Damage to or loosening of hinges, and latches
• Evidence of dropping or abuse
Before turning on microwave power for any service
test or inspection within the microwave generating
compartments, check the magnetron, waveguide or
transmission line, and cavity for proper alignment,
integrity, and connections.
Any failed or misadjusted components in the
interlock, monitor, door seal, microwave generation,
and transmission systems shall be repaired, replaced
or adjusted by procedures described in this manual
before oven is released to the consumer.
Check microwave leakage to verify compliance with
the federal performance standard should be performed
on each oven prior to releasing to the consumer.
WIRING
Good service practice is to never route wiring over
terminals and/or sharp edges. This applies to any wiring
without regard to the circuit voltage. Wire insulation
material and thickness is designed and regulated for
electrical spacing purpose only, but cannot always be
relied upon because of possible cuts and/or abrasions,
which can occur during servicing.
Important Product Information
To Next Page
Loading...
Need help?
General
