8
User’s Guide
9125921 BB Revised 07/28/14
Hinged Patio Doors
Door
Jamb
Center
Strike
Plate
Battery
Tray
Battery
Tray
Interior View
Small
Needle Nose Pliers
Battery Replacement Instructions - continued
Hinged Patio Doors
1. Unlock and open the door panel. Secure the door
panel in the open position (e.g. chair).
2. Locate the battery tray at the top of the center
strike plate in the door jamb.
3. Using a small needle nose pliers, grip the center
of the battery tray to remove. Take care to avoid
scratching the center strike plate finish.
4. Remove the discharged batteries (see battery
disposal information on page 4).
5. Replace the batteries with (2) two fresh CR-1632
lithium coin cell batteries. Take care to properly
position the “+” terminals of both batteries to
correspond with the “+” marking on the battery
tray for proper battery polarity.
6. Insert the battery tray back into the sensor
through the opening in the center strike plate.
The tray may encounter light resistance during
insertion. Continue until the outside edge of the
battery tray is flush with center strike plate.
7. Close and lock the door unit.
8. Verify that the sensor is communicating with the
security control panel by unlocking the door and
checking the keypad for the door unlock message
and then opening the door and checking the
keypad for the door open message.
To Next Page
Loading...
Need help?
General
