Angelo Po 0G1FR3G User Manual

C139603300_2.fm
- 7 -
IT
AUS
DE
FR
ES
SWITCHING THE BURNER ON AND OFF
The lighting and turning off procedure is as described
below for both burners.
Lighting
1 - Turn on the gas supply tap.
2 - Turn the knob (A) clockwise (pos. a) to turn on the
gas supply.
N.B.: the mains light (B) comes on.
3 - Open the hatch (C).
4 - Press the knob (D) and turn it anti-clockwise (pos.
e) to light the pilot light. Keep the knob pressed for
about 15 sec. to trip the thermocouple.
5 - Press the knob (D) and turn it anti-clockwise (pos.
f) to light the burner.
6 - Close the hatch (C).
7 - Turn the knob (A) clockwise (pos. b) to the tem-
perature required.
N.B.: the temperature light (E) comes on to indicate that
the oil is not at the working temperature; the light goes out
when the temperature is reached.
Turning off
1 - Turn the knob (A) anti-clockwise (pos. c) to turn
off the burner.
N.B.: the pilot light will remain on to allow the burner to
be re-lit.
2 - Open the hatch (C).
3 - Press the knob (D) and turn it clockwise (pos. g) to
turn off the pilot light.
4 - Close the hatch (C).
5 - Turn the knob (A) anti-clockwise (pos. d) to turn
off the mains gas supply.
N.B.: the mains light (B) goes out.
6 - Turn off the gas supply tap.
7 - Operate the appliance's circuit-breaker to dis-
connect it from the electrical mains.
e
g
f
DC
IDM-39603310700.tif
d
c
b
a
IDM-39603311400.tif
A B
E

Angelo Po 0G1FR3G Specifications

General

Brand	Angelo Po
Model	0G1FR3G
Category	Fryer
Language	English