6 7
WI-FI SETUP
Configure the thermostat to connect
to the Wi-Fi network.
Open a web browser on your computer or mobile
device. In the browser enter:
http://192.168.1.99/index.html
In the web browser interface select the network you
want to connect the thermostat to, and enter the
network’s security credentials.
STEP 3 STEP 4
Verify the thermostat is connected
to the Wi-Fi network.
Once all the required information is entered in the
web browser interface, the thermostat will connect to
the Wi-Fi network you selected. After the thermostat
is connected to the Wi-Fi network, the thermostat
will display the radio bars based on the Wi-Fi signal
strength. If the radio bars are not displaying the signal
strength, refer to Troubleshooting Wi-Fi Connection on
pages 15-16.
Note: If you are not using the thermostat with a home
automation system, but are instead using an Aprilaire
account to communicate with the thermostat, refer
to Wi-Fi Thermostat App User Guide and then
Start Up on my.aprilaire.com for instructions on
connecting to Wi-Fi and registering to an Aprilaire
account. For additional instructions on using the
Aprilaire web and mobile Apps refer to Wi-Fi
Thermostat App User Guide on my.aprilaire.com.
OPERATION & PROGRAMMING
SELECT SYSTEM MODE
(OFF/HEAT/EM-HEAT/COOL/AUTO)
Press
to select:
AUTO: Thermostat automatically selects heating or
cooling depending on the indoor temperature.
OFF: Heating and cooling systems are off.
HEAT: Thermostat controls only the heating system.
COOL: Thermostat controls only the cooling system.
EM-HEAT: Thermostat controls emergency/auxiliary
heat. Heat pump will not operate. (Only for heat pumps
with auxiliary heat.)
Press or to adjust the current setting.
In AUTO use
to switch between the HEAT and
COOL setting.
CHANGE TEMPERATURE SETTING
To Next Page
Loading...
Need help?
General
