Headlight adjustment (03_20, 03_21)
For a quick check of the correct direction of the front light beam, place the vehicle ten
metres from a vertical wall and make sure the ground is level.
Turn on the low beam light, sit on the vehicle and check that the light beam projected
to the wall is a little below the headlight horizontal straight line (about 9/10 of the total
height).
03_20
03_21
To adjust the light beam:
•
Loosen the nut «1».
•
Adjust the angle of the headlamp «2».
•
Tighten the nut «1».
•
Check that nut «1» is adequately tightened.
•
Check once again that the headlamp «2» is adequately directed.
NOTE
IN COMPLIANCE WITH LOCAL LEGISLATION, SPECIFIC PROCEDURES MUST
BE FOLLOWED WHEN ALIGNING THE LIGHTS.
85