64
use and maintenance Pegaso 650 I.E. STRADA - TRAIL
REAR WHEEL
CAUTION
The disassembly and reassembly of the
rear wheel may be difficult for unskilled
operators.
If necessary, contact your aprilia
Authorised Dealer.
If you want to perform these operations
personally, keep to the following
instructions.
Carefully read page 57
(MAINTENANCE).
WARNING
Before carrying out the following
operations, let the engine and the
silencer cool down until they reach
room temperature, in order to avoid
burns.
WARNING
Riding with damaged rims may be
dangerous for the rider, other persons
and the vehicle.
Check the conditions of the wheel rim
and have it changed it if damaged.
DISASSEMBLY
u Position the vehicle on the appropriate
rear support stand, see page 67
(POSITIONING THE VEHICLE ON THE
REAR SUPPORT STAND J).
u Put a support (1) under the tyre, in such
a way as to keep the wheel in its position
after loosening it.
u Unscrew and remove the nut (2) and
retrieve the washer (3).
Wheel nut (2) tightening torque: 100 Nm
(10 kgm).
NOTE To facilitate the extraction of the
wheel shaft, slightly raise the wheel.
u Withdraw the wheel shaft (4) from the
right side.
NOTE Slide the drive chain (5) off the
sprocket (6).
u Make the wheel advance and release the
drive chain (5) from the rear sprocket (6).
u Withdraw the wheel from the swinging
arm from behind, carefully withdrawing
the disc from the brake calliper.
u Remove the support plate (7) together
with brake calliper (8).
1
87
4
1
2 3
5 6
Pegaso650IE-E.book Page 64 Tuesday, September 26, 2006 5:51 PM
To Next Page
Loading...
Need help?
General
