Aqua Computer mps flow 100 User Manual

MPS
the cable. For further electrical connections and configuration of the pump,
please refer to chapter eight and following chapters.
7.5. Approved coolants
7.5. Approved coolants7.5. Approved coolants
7.5. Approved coolants
The D5 pump motor may solely be used with either Aqua Computer Double Pro-
tect Ultra or a (automotive) coolant based on water and glycol!
8. Electrical connectors
8. Electrical connectors8. Electrical connectors
8. Electrical connectors
ATTENTION: Completely turn off your power
supply or disconnect the mains power cord
from the wall outlet before connecting or dis-
connecting any cables to/from the device!
8.1. Connector „USB“
8.1. Connector „USB“8.1. Connector „USB“
8.1. Connector „USB“
This connector is used for USB communication
to the PC and for power supply. Connect to an
internal USB header of your motherboard. Take special care to make sure the pin
alignment matches your motherboard!
Pin assignment: Pin 1: +5 V(red)
Pin 2: D- (white)
Pin 3: D+ (green)
Pin 4: GND(black)
Pin 5: GND
8.2. Connector „aquabus“
8.2. Connector „aquabus“8.2. Connector „aquabus“
8.2. Connector „aquabus“
Connectors for communication with other devices from Aqua Computer. If con-
nected to an aquaero 5/6 controller by a 4 pin aquabus cable (53122), the USB
connection to the PC may be disconnected after initial configuration. In this case,
power will be supplied through the aquabus connection from the aquaero 5/6.
Compatible devices:
● aquaero 6 XT (53146, 53206)
● aquaero 6 PRO (53145)
● aquaero 6 LT (53234)
● aquaero 5 XT (53125, 53089)
● aquaero 5 PRO (53090)
● aquaero 5 LT (53095)
Pin assignment: Pin 1: GND
Pin 2: SDA
Pin 3: SCL
Pin 4: +5 V
- 10 - Aqua Computer GmbH & Co. KG © 2012-2016
Gelliehäuser Str. 1, 37130 Gleichen
c
o
m
p
u
t
e
r
a
q
u
a

Aqua Computer mps flow 100 Specifications

General

Brand	Aqua Computer
Model	mps flow 100
Category	Water Dispenser
Language	English