Page 12
User Manual for CD72/95/15003
A
RMING A SPLIT SYSTEM
As explained at the beginning of the chapter “Using a split system,” a split system can be programmed
to show two different standby message displays, and two different ‘selection’ messages after entering
your code. The instructions below use the displays “Time/Date” and “Area
[
number
]
armed.”
If your code lets you access more than one security area, you can select one of them to arm.
1. Go to the keypad. The current date and time are
displayed. An example is shown.
TUE 23 APR 07.40
2. Press the key
0
and then enter your code. A ‘*’ appears in the
display for every key you press. Use the
0
key to cancel an
incorrect entry and to restart a new entry of the code.
Enter Code
0 + code
Enter Code ****
In this example, areas 1 and 2 are disarmed.
Area 1 Disarmed
Area 2 Disarmed
You have a few seconds to enter the number of the area
you want to arm.
Enter Area No.
3. Enter the area number (in this example it is 1).
1
Arm Menu
4. Press the
Accept
key.
!
!!
!
Normal Set
5. Press the
Accept
key again.
!
!!
!
If you want to exclude zones in the area (open zones), press
the arrow key (
↑
). This feature is explained in the section
“Arming a system which has open zones.” Otherwise do
nothing: the message ‘Area 1 Arming’ appears automatically.
Normal Set
"
Area 1 Arming
Area 1 is arming. If programmed, the buzzer for the
system will begin.
Beeeep
Leave Now
Area 1 Armed
Area 2 Disarmed
Enter Area No.
6. If you also want to arm area 2, enter the number 2 into
the keypad.
2
Arm Menu
To Next Page
Loading...
Need help?
General
