Page 8
User Manual for CD72/95/15003
Beeeep
The alarm is now set.
System Armed
The current date and time automatically appears.
TUE 23 APR 07.40
A
RMING A SYSTEM WITH OPEN ZONES
When arming (switching on) the system, you may get the message
‘Open Zone(s)’
along with a list of
the zones in the premises that have not yet been closed. You should close these zones and then retry
arming the system. However, occasionally you may not be able to close an open zone because, for
example, a door lock or magnetic contact may be malfunctioning. You can exclude this open zone from
the system (called inhibiting a zone).
Only use this exclusion option when absolutely necessary as any inhibiting of zones will reduce the
security level of your system.
Although you can exclude an open zone when the tamper alarm has been triggered (identified by the
letter ‘T’ in front of the open zone listed), you will not be able to arm the system until the tamper alarm
has been rectified.
1. Go to the keypad. The current date and time appear on
the display. An example is shown.
TUE 23 APR 08.21
2. Press the key
0
and then enter your code. A ‘*’ appears in
the display for every key you press. Use the
0
key to
cancel an incorrect entry and to restart a new entry code.
Enter Code
0 + code
Enter Code ****
Arm Menu
3. Press the
Accept
key.
!
!!
!
Normal Set
4. Press the
Accept
key again.
!
!!
!
Normal Set
"
System Arming
The system has identified zones in the premises that are
not properly closed.
Open Zone(s)
It then proceeds to list the open zone(s). In this example,
zone 2 ‘Hall’ is open.
002 Hall
5. Press
"$
"$"$
"$
to exclude a zone from the system.
"
""
"
Inhibit Zone ___
To Next Page
Loading...
Need help?
General
