User Manual for CD72/95/15003
Page 15
D
ISARMING A SPLIT SYSTEM
If you enter the premises when the system is armed, the buzzer will begin to beep (if programmed) with
an intermittent tone to indicate that the entry period has begun. As long as this beeping continues, you
can disarm (switch off) the system with your code without activating an alarm. You also must not enter
other areas of the system during the beeping. If you do, a siren will sound and a full alarm condition
may occur. The entry period (length of time of the beeping) is programmed by the installer.
1. Go to the keypad. The entry period starts as soon as you
open the entrance door, or when you enter the entry
zone. You can switch off the system without activating the
alarm as long as the beeping continues.
Beep Beep
The current day, date and time are displayed. An example
is shown.
TUE 23 APR 07.39
2. Press the key
0
and then enter your code. A ‘*’
appears in the display for every key you press. Use the
0
key to cancel an incorrect entry and to restart a new entry
of the code.
Enter Code
0 + code
Enter Code ****
In this example, area 1 is armed and area 2 disarmed.
Area 1 Armed
Area 2 Disarmed
You have a few seconds to enter the number of the area
you want to switch off.
Enter Area No.
3. Enter the area number (in this example it is 1).
1
Disarm?
4. Press the
Accept
key to confirm you want to switch off
area 1.
!
!!
!
Area 1 Disarmed
Finished?
5. Press the
Accept
key to confirm you have finished.
!
!!
!
Area 1 Disarmed
Area 2 Disarmed
6. If you want to disarm or modify another area, enter its
number.
If you are finished, do nothing. The standby display
message will automatically appear after a few seconds.
Enter Area No.
Steps 4 and 5 may be automated by the system. If so,
you will not have to press the
Accept
key.
TUE 23 APR 07.40
To Next Page
Loading...
Need help?
General
