User Manual for CD72/95/15003
Page 9
6. Press the number of the open zone, in this example ‘2.’
2
Inhibit Zone 2
The system then confirms which zone you have excluded.
002 Hall
If another zone is open, it will be listed and you must
again press
"
""
"
and the zone number to inhibit it.
Is Inhibited
The alarm is being set.
System Arming
The buzzer begins to beep. You must now exit the
protected area by the designated exit route.
Leave now
Beeeep
The alarm is now set.
System Armed
The current date and time will automatically appear.
TUE 23 APR 08.22
D
ISARMING A SYSTEM
If you enter the premises when the system is armed, the buzzer will begin to beep (if programmed) with
an intermittent tone to indicate that the entry period has begun. As long as this beeping continues, you
can disarm (switch off) the system with your code without activating an alarm. You must not enter other
areas of the system during the beeping. If you do, a siren will sound and a full alarm condition may
occur. The entry period (length of time of the beeping) is programmed by the installer.
1. Go to the keypad. The entry period starts as soon as you
open the entrance door, or when you enter the entry
zone. You can switch off the system without activating the
alarm as long as the beeping continues.
Beep Beep
The current day, date and time are displayed. An example
is shown.
TUE 23 APR 07.39
2. Press the key
0
and then enter your code. A ‘*’ appears in
the display for every key you press. Use the
0
key to
cancel an incorrect entry and to restart a new entry code.
Enter Code
0 + code
Enter Code ****
Disarm?
3. Press the
Accept
key.
!
!!
!
Finished?
4. Press the
Accept
key to confirm that you have finished.
Steps 3 and 4 may be automated by the system. If so,
you will not have to press the
Accept
key.
!
!!
!
TUE 23 APR 07.40
To Next Page
Loading...
Need help?
General
