Aruba Instant On AP11 Access Point | Installation Guide 3
Reset Button
The reset button located on the bottom of the device can be used to reset the access point to factory default
settings or turn off/on the LED display.
There are two ways to reset the access point to factory default settings:
Reset the AP during normal operation
Press and hold down the reset button using a small, narrow object such as a paper clip for more than 10
seconds during normal operation.
Reset the AP while powering up
1. Press and hold down the reset button using a small, narrow object such as a paper clip while the access point
is not powered on (either via DC power or PoE).
2. Connect the power supply (DC or PoE) to the access point while the reset button is being held down.
3. Release the reset button on the access point after 15 seconds.
To turn off/on the LED display, press and release the reset button using a small, narrow object, such as a
paperclip for less than 10 seconds during normal operation of the access point.
Kensington Lock Slot
The AP11 access point is equipped with a Kensington lock slot for additional security.
Figure 3 AP11 Kensington Lock Slot
Cable Clips
The cable clips on the rear of the access point is used to organize Ethernet cable, as shown in Figure 4. The use of
the cable clips is optional and does not support all types of cables and plugs.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
