Aruba Instant On AP11 User Manual

Aruba Instant On AP11 Access Point | Installation Guide 7
Using the Wall/Ceiling Mount Bracket
Figure 9 Wall/Ceiling Mount Bracket
There are two ways to use the wall/ceiling mount bracket to mount the AP to a solid surface:
 Bracket-to-Solid Surface Option (Install the bracket to a solid surface and then attach the AP)
 AP-to-Bracket Option (Attach the bracket to the AP and then attach it to a wall)
Bracket-to-Solid Surface Option
1. Attach the plastic mount bracket to any solid surface, such as a wall or ceiling, as shown in Figure 10.
a. Install any necessary wall anchors. Wall anchors are not included in the package.
b. Align the screw holes in the mount bracket with the previously installed anchors or demarcated screw
points.
c. Insert two screws to secure the mount bracket. Screws are not included in the package.
Figure 10 Attaching the Mount Bracket to a Solid Surface
2. Attach the AP to the secured mount bracket as shown in Figure 11.
a. Align the AP with the mount bracket, placing the AP so that it’s mounting tabs are at an angle of
approximately 30 degrees to the mount bracket.
3. Pushing towards the solid surface, rotate the AP clockwise until it clicks into place (see Figure 11).

Aruba Instant On AP11 Specifications

General

2.4 GHz	Yes
MIMO type	Multi User MIMO
Networking standards	IEEE 802.11ac, IEEE 802.11n, IEEE 802.3af
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Maximum data transfer rate	1167 Mbit/s
Maximum data transfer rate (5 GHz)	867 Mbit/s
Maximum data transfer rate (2.4 GHz)	300 Mbit/s
Output voltage	12 V
Placement	Ceiling, Wall
Product color	White
Cable lock slot type	Kensington
Antenna type	Internal
Antenna features	Integrated antenna
Antenna direction type	Omni-directional
Antenna gain level (max)	5.8 dBi
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	5 - 93 %
Security algorithms	WPA2
USB 2.0 ports quantity	-
Ethernet LAN (RJ-45) ports	1

Weight and Dimensions

Width	152 mm
Height	34 mm
Weight	193 g