Disassembly Procedure
V1.0
IO Board
The illustrations below show how to disassemble and remove the IO Board.
1. Disconnect IO FFC from MB.
Assembly notice: 1) Insert FFC to the bottom until just accord with the line when lock the latch.
2) Please check whether the appearance of FFC/FPC is intact (not broken) and press the cable carefully before
assembly.
2. Remove 1 screw from hinge, pull up the hinge and take the IO board away.
Assembly Notice: Screw tightening torque: 3.0±0.25kgf-cm
To Next Page
Loading...
Need help?
General
