To Next Page

To Previous Page

EBL Drives and Controllers EN EBL RE-Drive and EBL RE Module

EBL RE-Drive and EBL RE Module

Introduction

The EBL RE-DRIVE and EBL RE Module screw counters are used to run and monitor work with EBL

screwdrivers and allow for excellent repeatability and a steady quality level.

Main functions:

■ Keep track of the number of screws tightened and allow verification of completion of work.

■ Distinguish between a OK tightening and a re-hit tightening.

■ Verify minimum time span for each tightening, as well as for time span per work piece.

■ Control external devices, such as total counters or jigs for fixing work pieces in place.

The EBL RE-DRIVE can drive a screwdriver directly. The EBL RE Module connects to a separate Drive.

Front Panel

EBL RE-DRIVE / EBL RE-MODULE

1 Operating Display LED ■ Green: Power on

■ Orange: Screwdriver function

enabled

2 Digital Display Displays set number of screws and

counts down.

3 Reset Switch Reset the counter functions, inter-

rupts output of the valve signal and

releases the work piece held by an

external device. If operated during

or after setting the set switch, the

display returns to the number that

was set. Performs the same func-

tion as the reset on the terminal

block on the rear panel.

4 6-Pin Tool Connector Connects the screwdriver cord.

5 Function Switch 1 Enter Change Function Mode if

pressed for more than one second

after reset. Pressing the button for

longer than one second while in

Change Function Mode will cause a

buzzer to sound, exit the Change

Function Mode.

6 Function Switch 2 (x10) Numbers increase in increments of

1 as the button is pressed.

Atlas Copco EBL Drive User Manual

Questions and Answers: