Atlas Copco Tensor User Manual

9
HIGH SPEED RUNDOWN
High Speed Rundown allows the tool to make the rundown at a
higher speed than Step 1 Speed. The function is used when a
fastener has a long rundown angle and there is a risk for
overshooting when the joint is hard.
SELF TAP
The Self Tap function is used for thread forming screws and
other fasteners with a torque pulse in the beginning of the
rundown higher than the desired 1
st
target or final target, see
graph below.

Atlas Copco Tensor Specifications

General

Category	DC Drives
Brand	Atlas Copco
Name	Tensor
Output Power	Varies by model (Consult specific product documentation)
Input Voltage	Varies by model (Consult specific product documentation)
Output Voltage	Varies by model (Consult specific product documentation)
Communication Interfaces	Ethernet, Fieldbus
Enclosure Rating	IP20 (typical, may vary by model)