- 50 -
AIR RECEIVER
The air receiver (1) is tested according to official
standards. Regularly have inspections carried out in
conformity with local regulations.
SAFETY VALVE
Following checks must be carried out on the safety
valve (2):
a check of the opening of the lifting gear, twice a
year. This can be done by screwing the cap of the
valve anti-clockwise.
a check of the set pressure once a year according
to the local regulations. This check cannot be done
on the machine and must be carried out on a
proper test bench.
FUEL SYSTEM
Replacing the filter element
1. Unscrew the filter element (1) from the adapter
head.
2. Clean the adapter head sealing surface. Lightly oil
the gasket of the new element and screw the latter
onto the header until the gasket is properly seated,
then tighten with both hands.
3. Check for fuel leaks once the engine has been
restarted.
All adjustments or repairs are to be done
by an authorized representative of the
valve supplier.
To Next Page
Loading...
Need help?
General
