The regulator will not accept new values beyond the limitations.
It is possible to check the limitations which are valid for the parameter to be modified by
selecting “Limits”.
3.21 Timers menu
Control panel
Function
To program time-based start/stop commands for the compressor.
Procedure
Starting from the Main screen (see Main screen menu):
• Press key “Menu” (F1).
• Press key (1) until “Timers” is shown.
• Activate the menu by pressing key “Select” (F2).
Initially, the list with start/stop commands is empty, hence the timer function is switched off. Following
screen appears:
The timer is
Not activated
.
Menu Modify List
F1 F2 F3
Programming start/stop commands
• Press the key “List”. The display will show a message that the list is empty.
• Press the keys “Modify” and “Add”. The command “Monday 00:00 Stop Compressor” will be shown.
Instruction book
64 2920 1815 04
To Next Page
Loading...
Need help?
General
