EasyManuals Logo
Home>Atlas>Amplifier>AA35

Atlas AA35 User Manual

Atlas AA35
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Specifications are subject to change without notice
AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435
©2006 ATLAS SOUND LP Printed in U.S.A. 000106 ATS002171 RevA 01/06 PP
OWNER'S MANUAL
AA35 MIXER AMPLIFIER
4
SAFETY PRECAUTIONS
Read the instructions very carefully before using this product.
Observe the instructions in this manual as conventions of safety; symbols and messages regarded as
important precautions are included.
Retain this manual for future reference.
Message Conventions and Safety Symbols
Before installing and operating this product, read this manual so you are fully aware of the potential
safety hazards and understand the safety symbols and messages. The safety symbols and messages
shown below are used in this manual to prevent bodily injury and property damage from mishandling.
Indicates a potentially hazardous situation which, if mishandled, could result
in death or serious injury.
Indicates a potentially hazardous situation which, if mishandled, could result
in moderate or minor personal injury, and/or property damage.
WHEN INSTALLING THE PRODUCT
Do not expose the product to rain or in an environment where it may be exposed to water or other
liquids, which may result in fi re or electric shock.
Operate the product only with the voltage specifi ed on the unit. Fire and/or electric shock may result if
a higher voltage is used.
Do not modify, kink, or cut the power cord. Do not place the power cord in close proximity to heaters
and do not place heavy objects on the power cord, including the product itself, doing so may result in
re or electric shock.
Replace the protective cover over the speaker terminals after installation. Do not touch the 70V
speaker terminals as electric shock may result.
Ensure that the safety ground terminal is connected to a proper ground. Never connect the ground to
a gas pipe as a catastrophic disaster may result.
Be sure the installation of the product is stable, avoid slanted surfaces as the product may fall and
cause injury or property damage.
WHEN THE DEVICE IS IN USE
To prevent electric shock, do not remove the product cover as there are high voltage components
inside. Refer all servicing to Atlas Sound.
Should any of the following irregularities occur during use, immediately switch off the power,
disconnect the power cord from the AC outlet and contact Atlas Sound. Do not to attempt to continue
operation with the product as this may cause fi re or electric shock:
Smoke or strange smell coming from the unit.
If the product falls or the case is damaged.
WARNING
CAUTION
WARNING
WARNING

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Atlas AA35 and is the answer not in the manual?

Atlas AA35 Specifications

General IconGeneral
Package weight4630 g
Amplifier class-
Frequency range50 - 20000 Hz
Output impedance8 Ω
Audio output channels3.0 channels
Peak power per channel35 W
Signal-to-Noise Ratio (SNR)- dB
Total Harmonic Distortion (THD)- %
PurposePerformance/stage
Product colorBlack
Volume controlRotary
Bass adjustmentYes
Channels quantity3 channels
Connectivity technologyWired
AC input voltage110 - 120 V
Power source typeAC
Speakers connectivity typePhoenix / RCA
Weight and Dimensions IconWeight and Dimensions
Depth276 mm
Width210 mm
Height93 mm

Related product manuals