1
The polarity of TS-SW：
Polarity, also called as phase sometimes, means that the input voltage is positive or
negative in specific time. In most cases, the positive will drive thediaphragm of the
speaker to move forward,and the negative will drive it backward. When a specific
frequency signal or similar signal repeats, the polarity must be the same, so that the
input efficiency will be the highest. For subwoofer system, this is very important. Wrong
connection or usage will change the polarity, and lower the system's efficiency.
TS-SW series polarity can be changed according to different using conditions.
When full range speakers system and subwoofer speaker system are combined,
please change the phase according to their distance to get the best sound performance.
6
1
1
MIX O UT A
OUT PUT A
1
1
2
11
6
4
5
1
2
3
7
9
8
13
16
10
12
17
14
15
AC IN PUT
(23 0V/50- 60 )Hz
Page 7
TS series back panel control and function
Audiocenter subwoofers or subwoofers of other brands are recommended to work with
TS.
To match with Audiocenter TS series or third party 2-way speaker systems, TS-SW
series are designed with 3 different kinds of presets:80Hz,100Hz and 120Hz. .
power indicator
When speaker connected to power, the LED is on.
Channel A signal indicator
When decting Line A/MIC channel has input signal, the LED is on.
Channel B signal indicator
When decting Line B/AUX channel has input signal, the LED is on.
Limiter indicator
When output limiter is activated, the LED is on. If the output voltage of the amplifier is
over the maximum value, the output limiter will operate to damp the output signal of
amplifier.
Protect Indicator
When the protection system is activated, the LED is on. The protection system will
operate in the following situations:
2
3
TS/TS-SW
4
5
To Next Page
Loading...
Need help?
General
