4.4 Advanced settings
4.4.1 Resetting to default settings
You can reset most of the thermostat settings to their default settings at
the same time.
Important
All connection settings for communication will be deleted too!
The temperature schedules, control mode and holiday period
will not be reset.
1. Enter the main menu.
2. Select Settings.
3. Select Reset to default settings.
4. Select Reset.
5. Confirm the selection.
The display will show ‘welcome’ in all languages.
6. Press the select button to continue.
The setup procedure will start.
For more information, see
Setup procedure, page 40
4.4.2
Check for software update
If your thermostat is connected to wi-fi, the internet and the server,
software will be updated automatically. You can check the status of the
software:
1. Enter the main menu.
2. Select Settings.
3. Select Check for software update.
The display shows the status of the software.
4.4.3 Temperature calibration
You can manually calibrate the temperature if the thermostat displays a
temperature that does not correspond with the actual room temperature.
This procedure should normally not be necessary.
1. Wait for at least 30 minutes after installation of the thermostat.
2. Measure the actual room temperature.
3. Enter the main menu.
4. Select Settings.
5. Confirm the selection.
6. Select Temperature calibration.
7. Confirm the selection.
The display shows the temperature measured by the thermostat as
Temperature detected.
8. If the detected temperature does not match with the temperature you
have measured: turn the rotary dial to change the temperature at
Calibrate this temperature to.
9. Confirm the change.
Important
It may take some time before the thermostat shows the new
offset on the Current Temperature.
The new offset will be used over the entire temperature range.
Fig.40
<1
bienvenido
welkom
welcome
benvenuto
velkommen
willkommen
bienvenue
<1
Fig.41
....... ....... : 0.0 ..
<1
....... ....... : 0.0 ..
4 Customisation
7718216 - v.02 - 26042019 29
To Next Page
Loading...
Need help?
General
