Foreword
BK9053, BK91038 Version: 2.3.0
Notes on the firmware versions
BK9103
Firmware Description
C0 • Supported terminals - KL6781, KL8519, KL8524, KL8528 and KL8548
BF • The record index 0x1010 can be used to deselect a parametrization (= write) of the
K-bus -> e.g. for the IO-Link terminal
BE • Internal buffer for frames increased
BD • Support compact mapping for KL6051
• After a K-bus reset via KS2000 or DAP Ctrl the AR is always disassembled
• Only one LLDP is accepted; the REMMIB is not deleted and a new neighbor is not
accepted until the TTL has elapsed
BC • Reading of the RemPort MIB rectified (via SNMP)
BB • GSDML for Schema V2.3
• MRP client is now supported
• Multiple write is supported
BA • In the event of a pull/plug alarm only the states of the affected modules are set to
BAD/GOOD
B9 • Support of KL6224 (IO-Link master)
B8 • I&M2 and I&M3 supported
B7 • HD terminals included
B6 • KL2791, KL1212, KL2641 implemented
• Step 7 online view supported
B5 • Alias name revised
B4 • LLDP, SNMP implemented
• I&M0, I&M1, I&M4 supported
B3 • Support for all KL terminals
B2 • Support for new Bus Terminals implemented.
• KL3xxx and KL4xxx can now also be entered in compact form.
B0 • First published
BK9053
Firmware Description
• Supported terminals - KL6781, KL8519, KL8524, KL8528 and KL8548
B7 • The record index 0x1010 can be used to deselect a parametrization (= write) of the
K-bus -> e.g. for the IO-Link terminal
B6 • Internal buffer for frames increased
B5 • Support compact mapping for KL6051
• After a K-bus reset via KS2000 or DAP Ctrl the AR is always disassembled
• Only one LLDP is accepted; the REMMIB is not deleted and a new neighbor is not
accepted until the TTL has elapsed
B4 • Reading of the RemPort MIB rectified (via SNMP)
B3 • Support of KL6224 (IO-Link master)
• GSDML for Schema V2.3
B2 • Firmware released
B0 • First publication (preliminary)
To Next Page
Loading...
Need help?
General
