For your safety
Version: 1.0 ───
15XPlanar
Only use original packaging for further processing
When shipping, transporting, storing and packing, use the original
packaging or conductive materials.
2.2.2During operation
Observe the GND concept
During the installation, follow the common guidelines for grounding
electrical components. For grounding please refer to the chapter on
"Grounding the machine bed", [Page59].
Do not work on live electrical parts
Ensure proper connection of the protective conductor. Never loosen
electrical connections when live. Do not work on the XPlanar unit
until the voltage has dropped below 10 V. Disconnect all compo-
nents from the mains and secure them against being switched on
again.
Do not touch hot surfaces
Check the cooling of the surfaces with a thermometer. Do not touch
the components during and immediately after operation. Allow the
components to cool sufficiently after switching off.
Avoid overheating
Operate the components according to the technical specifications.
Please refer to chapter: "Technical data". Provide for sufficient cool-
ing. Switch the components off immediately if the temperature is too
high.
Do not touch any moving or rotating components
Do not touch any moving or rotating parts during operation. Fasten
all parts or components on the machine or plant.
2.2.3After operation
De-energize and switch off components before working on
them
Check the functionality of all safety-relevant devices. Secure the
working environment. Secure the machine or plant against being in-
advertently started up. See chapter: "Decommissioning"
To Next Page
Loading...
Need help?
General
