Mechanical Installation – Part 2: Mover
62
─── Version: 1.0XPlanar
9.1
Mover
WARNING
Do not position the mover until the electrical installation has
been completed
The movers may only be positioned once part 1 of the mechani-
cal installation and the electrical installation have been com-
pleted. Perform a tile system test before positioning the movers.
Failure to do so may result in serious injury to fingers from crush-
ing and to eyes from splinters.
Wear safety goggles and gloves
The movers can have strong magnetic attraction to each other or
other metallic objects. Splinters can form if magnets collide.
Failure to do so may result in serious injury to fingers and eyes.
Remove each mover individually from the box
If you take two movers out of the box and the distance between
the movers is too small, the movers can attract each other.
If the movers attract each other and collide, serious injuries to the
fingers from crushing and in the eyes from splinters can result.
Do not reach under the mover with your fingers
When carrying a mover or positioning it on the system, do not
reach under the mover with your fingers.
Failure to do so can result in severe crushing and injury to fin-
gers.
Movers contain strong permanent magnets
The permanent magnets are arranged in so-called Halbach ar-
rays, which ensure that the magnetic field on the underside of the
mover is significantly stronger than on the upper side of the
mover. The field of the permanent magnets is present even when
the power supply is switched off.
If the movers attract each other and collide, serious injuries to the
fingers from crushing and in the eyes from splinters can result.
To Next Page
Loading...
Need help?
General
