9 How to assemble your monitor hardware
To Connect the DVI-D Dual Link Cable
Connect the plug of the DVI-D Dual Link cable to the
monitor video socket. Connect the other end of the cable
to the computer video socket.
Tighten all finger screws to prevent the plugs from
accidently falling out during use.
The DVI-D format is used for direct digital connection
between source video and digital LCD monitors or
projectors. The DVI-D Dual Link cable is used to transfer
video signals to a monitor that runs in 120 Hz refresh rate
or 3D video signals. Video signals that are compatible
with DVI-D Dual Link format produce a superior quality
picture than analog and other DVI formats.
To Connect the HDMI Cable
Connect the plug of the HDMI cable to the HDMI port
on the monitor.
Connect the other end of the cable to the HDMI port of a
digital output device.
3. Connect the headphones.
You may connect headphones to the headphone jack
found on the left side of the monitor.
The audio output is available only when the audio signals
are input through HDMI.
4. Connect the power cable to the monitor.
Plug one end of the power cord into the socket labelled
‘POWER IN’ on the rear of the monitor. Do not connect
the other end to a power outlet just yet.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
