12
7.3 Wiring without positioner option
How to wire actuator
The wiring must be done according to the wiring diagram that
matches the characteristics of your actuator (see Chapter 11).
1. Using a 3×0.5 mm flat blade screwdriver, connect the power
supply on the terminals as indicated in the wiring diagram.
2. Crimp a ring cable lug on the ground cable.
3. Remove the screw using a 4 mm hex key.
4. Install a washer between the head of the screw and the ring
cable lug.
5. Tighten the screw.
6. Tighten the sealing nut on the cable gland when you have
completed the wiring.
Both thermal protector and torque limit switches must be
integrated into your control system to prevent potential damage to
the actuator or valve.
To Next Page
Loading...
Need help?
General
