Bernard Controls STX Series User Manual

14 15
9.5 ExITING ThE MENU AT ANY TIMES
To exit the menu at any time, turn the red selector to the “OFF” position.
9.6 MAIN MENU DESCRIPTION
Language: to choose the displayed language.
Check: to view all actuator settings and configuration data.
No changes can be made and this option can be accessed
without a password.
Setup: to adjust the actuator on the valve. A password is needed
to access this option if a password has been registered.
Change: to change the actuator configuration. A password is needed
to access this option if a password has been registered.
Refer to §12 to get details about the Check, Setup and Change menus.
10 SELECTING ThE DISPLAY LANGUAGE
Select language in the MENU and turn to OK to confirm.
Select the language you want and turn to OK to confirm.
11 PASSWORD
Users wishing to access the change or set up menus are prompted to
enter a password.
The default setting is no password and the change or
set up menus can be accessed by selecting OK.
The user can opt to add a password to restrict access to changes
Create password
Refer to section §24 “How to create or change a password”
Enter password
To enter password at the prompt CODE ?
Enter 1st digit with the blue selector and then turn to OK to confirm.
Enter 2nd digit with the blue selector and then turn to OK to confirm.
Enter 3rd digit with the blue selector and then turn to OK to confirm.
The user can continue if the access code is correct.
Select OK to confirm.
MENU
exit set up
language
check
setup
change
exit set up
LANGUAGE
French
English
Deutsch
Spanish
Portugues
Italian
Russian
Chinese
Polish
CODE?
0
user code
OK
ok
user code
OK
ok
EXIT
SETUP
LANGUAGE
CHECK
SET UP
CHANGE
EXIT
SETUP
MENU
RETURN
ACTIVITY
ALARMS
COMMANDS
no alarm
return
aux. command 1
aux. command 2
local command
local stop
remote stop
priority
fault tolerance
partial stroke
return
number of starts
running time
starts last 12h
handwheel action
TORQUE
return
torque setting
measured torque
torque curve
closing mode
sensor model
DATA
SHEET
return
valve tag number
actuator number
entry code
operating class
manufacture date
characteristics
software version
POSITION
return
close direction
opt position signal
sensor model
POSITIONER
return
signal range
dead band %
loss of signal
proport pulse
SIGNALING
return
opposite display
torque display
lights
LOCAL
INDICATION
return
relay 1
relay 7
fault relay
REMOTE
INDICATION
TIMER
return
timer open time
timer closed time
temporised zone
FIELDBUS
return
according to
bus interface
12 ChECK MENU FLOWChART

Bernard Controls STX Series Specifications

General

Brand	Bernard Controls
Model	STX Series
Category	Controller
Language	English