Shenzhen Big Tree Technology Co., Ltd.
BIGTREETECH
29 / 39
5. Wait for the writing to finish.
5.4 WIFI Setting
note：skip this step if you are using ethernet port not using WIFI
CB1 cannot directly use the Raspberry Pi Imager software to set the WiFi name
and password like CM4. After the system image writing is completed, the Micro
SD card will have a FAT32 partition recognized by the computer, Find
"wpa_supplicant.conf" file
Open it with Notepad, and replace WIFI-SSID with the actual WiFi name, and
PASSWORD with the actual password
To Next Page
Loading...
Need help?
General
