Shenzhen Big Tree Technology Co., Ltd.
BIGTREETECH
37 / 39
6.3 Firmware update
6.3.1 Update using SD Card
1. Rename klipper.bin to ”firmware.bin”, Copy to the SD card root directory,
insert the SD card into the SD card slot of the MANTA M8P, click the “reset”
button or power on again. The firmware will be updated automatically. After
the update, the "firmware.bin" in the SD card will be renamed as
"FIRMWARE.CUR".
2. Enter: ls /dev/serial/by-id/ in terminal to check motherboad ID to
confirm whether firmware is updated successfully like showm below.
copy and save this ID，it is needed when modifying klipper config
6.3.2 Update using DFU
If the MCU klipper device ID can be found by ls /dev/serial/by-id/, we can
input:
make flash FLASH_DEVICE= /dev/serial/by-id/usb-Klipper_stm32g0b1xx_190028000D50415833323520-if00
to update firmware (NOTE: Replace /dev/serial/by-id/xxx with the actual ID
found in the previous step)
There will be an error message “dfu-util: Error during download get_status” after
update. Just ignore it.
To Next Page
Loading...
Need help?
General
