TROUBLESHOOTING & WARRANTY
TROUBLE POSSIBLE REMEDY
If fan does not start
1. Check main and branch circuit fuses or circuit breakers.
2. Check wire connections as performed applicable installation
pages 11-16. CAUTION: Make sure main power is turned o.
3. Make sure forward/reverse switch is firmly in right or left
position. Fan will not operate when switch is in the middle.
4. If the fan still will not start, contact a qualified electrician. Do
not attempt to troubleshoot internal electrical connections
yourself.
5. If remote is being used, check batteries.
If fan sounds noisy
1. Check to make sure all screws in motor housing are snug
(not over tightened).
2. Check to make sure the screws which attach the fan blade
holder to the motor are tight.
3. Allow “break-in” period of 24 hours. Most noises associated
with a new fan will disappear after this period.
If fan wobbles
1. Check that all blades are screwed firmly into blade holders.
2. Check that all blade holders are tightened securely to motor.
3. Make sure that canopy and mounting bracket are tightened
securely to ceiling joist.
4. If blade wobble is still noticeable, interchanging two
adjacent (side by side) blades can redistribute the weight
and possibly result in smoother operation.
If light does not work
1. Check for faulty light bulbs.
2. Check to see that the wire connections in the switch
housing are connected.
3. If light kit will still not operate, contact a qualified electrician
for assistance.
Troubleshoot your problem by using the chart below. If the appliance still does not
work properly, contact W Appliance Co. customer service center. Customers must
never troubleshoot internal components.
Page 25
To Next Page
Loading...
Need help?
General
