40
SERVSWITCH™ JR.
Appendix A: NVRAM Factory Defaults
The table below shows, for the ServSwitch Jr.’s saveable options, the default values
stored in nonvolatile memory (NVRAM) when the Switch is shipped from the
factory. It also shows what commands or actions can change these settings for the
Switch’s current operating period, as well as what commands or actions can save
changed settings to NVRAM, so that they become the new defaults.
Option Factory-Default To Change To Save
Setting Changes
Caps/Scroll/ Num Lock ON (fixed) Select port, then press the Can’t be saved
Num Lock corresponding button on the
keyboard
Scan OFF Type [Ctrl] S (to turn ON) or Can’t be saved
[Ctrl] X (to turn OFF)
Scan-Delay 5 seconds Type [Ctrl] Txx [ENTER] [Ctrl] K
Time (xx = 1 to 15, time in seconds)
Maximum SW622A-R2: Four Type [Ctrl] Px [ENTER] [Ctrl] K
Ports SW629A-R2: Eight (x = 2 to 7)
Keyboard Mode 2 Select port, then type [Ctrl] Mx [Ctrl] K
Mode (x = 1, 2, or 3)
Keyboard 43 (delay of 1/2 second, Type [Ctrl] Axxx [ENTER] [Ctrl] K
Typematic rate of 10.9 characters (xxx = 0 to 127; see
per second) Section 4.3.12)
PS/2 to RS-232 0 (OFF) for each computer Select port, then type
Mouse [Ctrl] 1 [ENTER] to turn ON or [Ctrl] K
Translation [Ctrl] 0 [ENTER] to turn OFF
To Next Page
Loading...
Need help?
General