EasyManuals Logo
Home>Black Box>Switch>ServSwitch SW724A-R5

Black Box ServSwitch SW724A-R5 User Manual

Black Box ServSwitch SW724A-R5
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
CHAPTER 2: Introduction
17
2.4 The Rear Panel
All cable connections are made at the rear panel of the ServSwitch, as
illustrated in Figures 2-4 and 2-5 and described below.
Figure 2-4. The rear panel of a 2 to 1 ServSwitch (SW721A-R5).
Figure 2-5. The rear panel of a 16 to 1 ServSwitch (SW725A-R5).
Panel Label Conn. Description
CPU N
[
N = a number
from 1 to
either 2, 4, 8,
12, or 16,
depending on
which model
you have]
DB25 F Connect your computers to these ports with “CPU
Adapter Cables.” At the ServSwitch end these cables
have a DB25 male connector; at the other ends, they
have appropriate connectors to plug into your CPUs’
video, keyboard, and mouse ports. These cables take
the signals that would normally pass between the
CPUs’ ports and the monitor, keyboard, and mouse,
and carry them between the CPUs’ ports and the
Switch instead.
You could also connect “submaster” Serv type
switches to these ports using “ServSwitch-to-
ServSwitch Expansion Cables.” These cables have
DB25 male connectors at both ends; at the submaster
end, they should be plugged into a MONITOR/
o
rt. Refer to Sections 2.5 and 3.2.4.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Black Box ServSwitch SW724A-R5 and is the answer not in the manual?

Black Box ServSwitch SW724A-R5 Specifications

General IconGeneral
BrandBlack Box
ModelServSwitch SW724A-R5
CategorySwitch
LanguageEnglish

Related product manuals