Chapter 3: Installation
31
If you see this, you will need to download correct firmware to the affected unit
as described in Section 4.4.3, starting at the point at which the unit is ready to
receive the file at 9600 baud (9600 bps). (In this case, you must download the
file at 9600 bps.)
6.Turn ON the computer identified as CPU 1. Wait until the boot process is
complete, then turn ON CPU 2, wait until it boots, turn ON CPU 3, etc., until
all of your computers are powered up.
7.Set each master’s Maximum computers, Expansion units, and Expansion
width values so that the master can scan correctly and properly control the
interplay of the submaster units. You can do this with the on-screen display—
see Sections 5.2.3 through 5.2.5.
8.You might need to set some or all of each master’s remaining configuration
parameters, especially the keyboard mode for some of your ports (see
Sections 5.2.1, 5.2.2, and 5.2.6 through 5.2.10).
9.Save the configuration changes you just made to the master unit’s nonvolatile
memory as described in Section 5.1.3.
Your cascaded ServSwitch system should now be ready for operation.
To Next Page
Loading...
Need help?
General