Auto CPAP / CPAP System User Manual V1.0
14 / 51
Fig. 11-2
(3) Change the air filter and filter cap to the PM2.5 filter, as shown in Fig. 11-3.
Fig. 11-3
CAUTION!
• The air filter or the PM2.5 filter must be in place when the device is operating.
11.3 Connecting to Power
(1) Insert the plug of the power adapter into the DC Inlet on the back of the device;
(2) Connect the power cord to the power adapter;
(3) Plug the other end of the power cord into the power outlet.
Power Adapter
Power Cord
DC Inlet
Fig. 11-4
WARNINGS!
• The device is powered on for use when the power cord and power adapter is connected.
The Knob
turns the blower On / Off.
• Use of the device at an AC voltage beyond the stated range (see Section 5 ―AC Power
To Next Page
Loading...
Need help?
General
